Click the button next to the maintenance function, then click Run to start the maintenance function.
If the tape drive is installed in a library, some of the maintenance functions cannot be run with the Ethernet procedure.
The status of the maintenance function is shown under the Drive Response. The web page is static so it must be refreshed frequently to show the current maintenance
function status.
Press Cancel now or Cancel at end of loop to stop the maintenance function. It can take several minutes for the maintenance function to end.
Troubleshooting
Edit online
Use the information in this section to troubleshoot any issues with your tape drive and configuration.
If you encounter problems when you run the drive, refer to the flowchart in Figure 1. For explanations of codes on the Single-character Display (SCD), see Single-character
display (SCD). Review the Pre-call checklist before IBM Technical Support is called.
Figure 1. Flowchart for Analyzing Maintenance Problems
To Next Page
Loading...