TIMER
→ TIMER (if enabled in the Basic Settings)
→ → Timer start
afterwards → → Timer stop
afterwards → → Timer reset
the cycle "Start, Stop and Reset" can started again
→ no function
→ no function
→ Multifunction key: The first push starts the timer, the next push stops
the stopwatch and pushing it again resets the timer.
If enabled in the basic settings menu this works as a stopwatch. By pressing the key e.g. the
stopwatch is being started, by pressing it again it is being stopped. Pressing the key a third time resets the
shown time to 00.00.00 and the stopwatch can be used again.
→ TIMER die display changes to MM/SS/DS automatically after 2 seconds
MM/SS/DS
00.00.0 ← tenth seconds
↑ ↑
↑ seconds
minutes
After 59 minutes and 59.9 seconds the display form changes so that hours, minutes and seconds are being
displayed. The tenth second display is not available then. After 9 hours, 59 minutes and 59 seconds the
stopwatch stops itself.
HH/MM/SS
0.00.00 ← seconds
↑ ↑
↑ minutes
hours
To Next Page
Loading...
