16
Programming (continued)
• Set time is displayed
8. Press the or button to change set time.
9. Press the button to advance to the next screen.
Note: Transitions required after 11:59 PM must be programmed in the
next day’s MORN transition.
• Heat temperature is displayed (45°F to 90°F)
10. Press the or button to adjust heat set temperature.
11. Press the button to advance to the next screen.
• Cool temperature is displayed (45°F to 90°F)
Note: Cool cannot be set lower than heat temperature.
12. Press the or button to adjust cool set temperature.
13. Press the button to advance to the next screen.
Repeat steps 1-13 to program each day of the week individually or use the
Simpleset
®
feature (see Page 17) to program every day the same as Monday.
When programming is complete, press and hold the button in for 5 seconds to return to the OFF mode.
PROG must display on the screen for the thermostat to follow the program schedule. If PROG does not
appear, press the PROG button until PROG displays.
To Next Page
Loading...
Need help?
General
