40
5
MEMORY AND SCAN OPERATION
• Programming in VFO mode
➀ Select M2 functions.
• Push [DISPLAY] 1 or 2 times to select M.
• Push [MENU] one or more times to select the
M2 func-
tions.
➁ Set the desired frequency and operating mode in
VFO mode.
• If you want to program the split frequency function, pro-
gram both receive and transmit frequencies into VFO A
and B, then turn ON the split function.
• If you want to program a repeater function, set a tone
frequency (p. 49) in addition to the receive/transmit fre-
quencies.
➂ Rotate [M-CH] to select the desired memory chan-
nel, or the call channel (144/430 MHz bands only).
•
Select memory mode to confirm the contents, if desired.
•“}” appears if the selected memory channel is a
blank channel (and does not have contents).
➃ Push [(F-1)MW] for 2 sec. to program the displayed
frequency and operating mode into the memory
channel.
To check the programmed contents, push [
(F-3)V/M]
to select memory mode; or, push [CALL] to select the
call channel.
■ Memory/call programming
• Programming in memory mode
➀ Set the desired frequency and operating mode.
➁ Select memory mode, then select the desired
memory channel with [M-CH].
• Push [Y]/[Z] when you want to program blank chan-
nels.
➂ Push [(F-1)MW] for 2 sec. to program the displayed
frequency and operating mode into the memory
channel.
To Next Page
Loading...
