41
5
MEMORY AND SCAN OPERATION
■ Frequency transferring
The frequency and operating mode can be transferred
from memory mode to VFO mode.
➀ Select VFO mode with [(F-3)V/M] in the M2 dis-
play.
➁ Select a memory channel with [M-CH].
• Select memory mode to confirm the memory channel’s
contents, if desired; then return to VFO mode.
•“
}” appears if the selected memory channel is a
blank channel (and does not have contents). In this
case transferring is not possible.
➂ Push [(F-2)MÜV] for 2 sec. to transfer the frequen-
cy and operating mode.
• Transferred frequency and operating mode appear in
the display.
•“
MÜV” does not appear in memory mode.
■ Memory names
All memory channels (including scan edges and the
call channel) can be tagged with alphanumeric names
of up to 9 characters each.
All common keyboard characters (ASCII characters
33 to 126) can be used, including numerals and punc-
tuation marks.
• Calling up memory names
➀ Select the G4 display.
➥ Push [DISPLAY] 1 or 2 times to select G.
➥ Push [MENU] one or more times to select the
G4 display.
➁ Select a memory channel with [M-CH].
• Editing (programming) memory names
➀ Call up the desired memory (channel) name as
above.
➁ Push [(F-3)É] to enter memory name edit mode.
•“name edit” appears briefly, then a flashing cursor
appears under the first character position.
➂ Rotate the main dial to select the desired charac-
ter, then advance the cursor position.
• [(F-3)Ç] increments the cursor position; [(F-1)Å] decre-
ments the cursor position.
• [(F-2)] overwrites the character with a space.
➃ Repeat this procedure until all desired characters
have been selected.
➄ Push [(MENU)Ä] to exit memory name edit mode.
• The G4 display reappears and the programmed mem-
ory name is displayed.
To Next Page
Loading...
