5
1
PANEL DESCRIPTION
■ Rear and side panels
q GROUND TERMINAL [GND] (p. 9)
Connect this terminal to a ground to prevent electri-
cal shocks, TVI, BCI and other problems.
w
ANTENNA CONNECTORS [ANT 1], [ANT 2] (p. 11)
Accept a 50 Ω antenna with an PL-259 type plug.
• [ANT 1] is for connection to an HF/50 MHz antenna.
• [ANT 2] is for connection to 144 MHz antenna.
• These connectors are switched above or below 60 MHz.
e
DATA JACK [DATA] (p. 12)
6-pin min DIN jack to connect a TNC, etc. for pack-
et operation.
r
ACCESSORY SOCKET [ACC] (p. 6)
Enables connection to external equipment such as
a TNC for data communications, a linear amplifier or
an automatic antenna selector/tuner, etc.
• See page at right for socket information.
t
RTTY JACK [RTTY] (p. 35)
Connects an external terminal unit for RTTY (FSK)
operation.
• The keying polarity and mark/shift frequencies can be
selected in quick set mode (p. 48).
y CI-V REMOTE CONTROL JACK [REMOTE]
(p. 45)
Designed for use with a personal computer for
remote operation of transceiver functions.
u MICROPHONE CONNECTOR [MIC] (p. 11)
Accepts the supplied microphone (connected in par-
allel with the front panel’s [MIC] connector).
• See pgs. 1 and 2 for microphone notes.
• See p. 8 for microphone connector information.
i ELECTRONIC KEYER JACK [KEY] (p. 33)
Accepts a paddle to activate the internal electronic
keyer.
• Selection between the internal electronic keyer and
straight key operation can be made in quick set mode.
(p. 49)
o DC POWER SOCKET [DC13.8V] (p. 13)
Accepts 13.8 V DC through the supplied DC power
cable.
!0 EXTERNAL SPEAKER JACK [EXT SP] (p. 12)
Accepts a 4–16 Ω speaker.
!1 TUNER CONTROL SOCKET [TUNER] (p. 12)
Accepts the control cable from an optional AH-3
HF
AUTOMATIC ANTENNA TUNER
.
!2 SPEECH COMPRESSION LEVEL CONTROL
[COMP GAIN] (p. 26)
Adjusts the compression level.
• This control is available only when the speech compres-
sor is ON.
To Next Page
Loading...
