58
11
OTHER FUNCTIONS
11
DD
DTCS code
Sets DTCS code (both encoder and decoder) for DTCS
squelch operation. Total of 104 codes are available.
(default: 023)
DD
DTCS polarity
Sets DTCS polarities for transmission and reception from
“NN,” “NR,” “RN” and “RR.” (default: NN)
DD
Offset frequency
Sets the duplex offset frequency within 0 to 20 MHz range.
During duplex (repeater) operation, transmit frequency (or re-
ceive when reverse function is set to ON) shifts the set fre-
quency.
(default value may differ depending on operating frequency
band and versions)
DD
Tuning step
Selects tuning step from 5, 10, 12.5, 15, 20, 25, 30, 50, 100
and 200 kHz for [DIAL] or [Y]/[Z] operation.
(default value may
differ depending on operating frequency band and versions)
To Next Page
Loading...
