Icom IC-208H - I Partial Reset; I All Reset

68
11
OTHER FUNCTIONS
11
■ Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents.
➥ While pushing [V/MHz•SCAN] and [SET•LOCK], push
[PWR] for 1 sec. to partially reset.
■ All reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the transceiver CLEARS all memory information
and initializes all values in the transceiver.
➥ While pushing [S.MW•MW] and [SET•LOCK], push [PWR]
for 1 sec. to reset the CPU.
[S.MW•MW]
[SET•LOCK]
[PWR]
AT POWER ON
[S.MW•MW]
[PWR]
[V/MHz•SCAN]
AT POWER ON