17
Section 8
SPECIFICATIONS
D General
• Frequency coverage:
CB 476.4250–477.4125 MHz
RX 450.000–520.000 MHz (RX only)
• Mode:
CB channel 8K50F3E
RX channel 8K50F3E/16K0F3E
• Channel spacing:
CB channel 12.5 kHz
RX channel 12.5/25 kHz
• Current drain (at 7.5 V): TX (at 5 W) approx. 1.7 A
Max. audio approx. 300 mA
• Power supply requirement: 7.5 V DC nominal*
(Negative ground)
*Specified Icom’s battery pack
only
• Frequency stability: ±2.5 ppm (–30°C to + 60°C)
• Antenna impedance: 50 Ω nominal
• Dimensions: W 52.2 × H 111.8 × D 30.3 mm
(Projections not included)
• Weight: Approx. 270 g (with BP-280)
D Transmitter
• Output power: 5 W/1 W (selectable)
• Modulation system: Variable reactance
frequency modulation
• Max. frequency deviation: ±2.5 kHz
• Spurious emissions: 70 dB (min)
D Receiver
• Receive system: Double conversion
superheterodyne
• Sensitivity (12 dB SINAD): 0.25 µV (typical)
• Squelch sensitivity: 0.25 µV (typical)
• Intermodulation rejection ratio: 73 dB (typical)
• Spurious response rejection ratio: 70 dB (min)
• Audio output power: 0.8 W (typical) at 5%
distortion with 12 Ω load
(INT)
0.4 W (typical) at 5%
distortion
with 8 Ω load
(EXT)
All stated specifications are subject to change without
notice or obligation.
To Next Page
Loading...
Need help?
General
