Icom IC-746PRO - Page 98

85
11
SET MODE
2001 NEW 2001 NEW
22. [ANT] Switch
You can set the antenna connector selection to auto-
matic, manual or non-selection (when using 1 an-
tenna only for the HF/50 MHz bands).
Auto : The antenna switch is activated and
the band memory memorizes the se-
lected antenna. (default)
Manual: The antenna switch is activated and
selects an antenna manually.
OFF : The antenna switch is not activated
and does not function. The [ANT1] con-
nector is always selected in this case.
22 Auto
[ANT] Switch
23. SPEECH Language
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can select between English and Japan-
ese as the language.
English : Announces in English (default)
Japanese : Announces in Japanese
See p. 90 for unit installation.
23 English
SPEECH Language
24. SPEECH Speed
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can select between faster or slower
synthesizer output.
HIGH : Announces faster (default)
LOW : Announces slower
See p. 90 for unit installation.
24 HIGH
SPEECH Speed
25. SPEECH S-Level
When the optional UT-102 VOICE SYNTHESIZER UNIT is
installed, you can have frequency, mode and signal
level announcement. Signal level announcement can
be deactivated if desired.
ON : Announces operating frequency, mode
and receiving signal level. (default)
OFF : Announces operating frequency and
mode only.
See p. 90 for unit installation.
25 ON
SPEECH S-Level
26. Memory Pad Ch
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set.
5 : 5 memo pads (default)
10: 10 memo pads
26 5
Memory Pad Ch
■ General set mode (continued)
IC-746PRO.qxd 02.4.2 11:32 Page 85