What to do if select memory scan does not start on Icom IC-7800 Transceiver?
If your select memory scan doesn't start on your Icom Transceiver, designate more than 2 memory channels as select channels for the scan.
What to do if memory scan does not start on Icom IC-7800 Transceiver?
If your memory scan doesn't start on your Icom Transceiver, program more than 2 memory channels.
How to fix Icom IC-7800 Transceiver if power does not come on?
If your Icom Transceiver's power isn't turning on, make sure the AC power cable is correctly connected. Also, check if the internal power supply is turned OFF and turn it ON. Finally, examine the circuit breaker and reset it if it has tripped after identifying the cause.
What to do if programmed scan does not stop on Icom Transceiver?
If your Icom Transceiver's programmed scan doesn't stop, set [SQL] to the threshold point.
Why the [ANT] switch does not function on Icom Transceiver?
If the [ANT] switch on your Icom Transceiver isn't functioning, make sure the antenna switch in set mode is set to 'Auto' or 'Manual'.
Why repeater cannot be accessed on my Icom IC-7800 Transceiver?
If you are unable to access a repeater with your Icom Transceiver, ensure the split frequency function is activated by pushing [SPLIT] to turn it ON. Also, check if the programmed subaudible tone frequency is wrong and reset it using set mode.
Why does the displayed frequency not change properly on my Icom IC-7800 Transceiver?
If your Icom Transceiver's displayed frequency isn't changing properly, here's what to check: * Push [LOCK] to turn the function OFF if the dial lock function is activated. * Push [EXIT/SET] several times to exit the set mode screen if a set mode screen is selected. * Reset the CPU if the internal CPU has malfunctioned.
Why doesn't frequency change on Icom Transceiver?
If the displayed frequency on your Icom Transceiver doesn't change properly, it could be due to a few reasons. The dial lock function might be activated; push [LOCK] to turn it OFF. A set mode screen might be selected; push [EXIT/SET] several times to exit the set mode screen. The internal CPU may have malfunctioned; try resetting the CPU.
Why is the transmit signal unclear or distorted on my Icom IC-7800 Transceiver?
If your transmit signal is unclear or distorted on your Icom Transceiver, adjust [MIC] to a suitable position, ensuring it is not set too far clockwise.
What to do if no contact possible with another station on Icom IC-7800?
If you can't make contact with another station using your Icom Transceiver, it might be due to the RIT or ?TX function being activated. Push [RIT] or [?TX] to turn these functions OFF. Also, check if the split frequency function and/or dualwatch are activated; if so, push [SPLIT] and/or [DUALWATCH] to turn them OFF.
General| Brand | Icom |
|---|---|
| Model | IC-7800 |
| Category | Transceiver |
| Language | English |
To Next Page
