4
SETTINGS
11
Setting the squelch level
The squelch circuit mutes the received audio signal,
depending on the signal strength.
Rotate q [VOL] to turn the transceiver power OFF.
Set w [ROTARY SELECTOR] to any channel other
than Channel 16.
While holding down e [Upper], rotate [VOL] to turn
ON the power and enter the squelch level adjust-
ment mode.
Push r [Upper] to increase the squelch level (tight
squelch), or push [Lower] to decrease the squelch
level (loose squelch).
•The adjustablerange is0 (open squelch) and 1 (loose
squelch) to 9 (tight squelch).
•A beep sounds after pushing [Upper] or [Lower]. An
error beep sounds if you try to exceed the adjustable
range.
NOTE: The Beep function should be turned ON. (p. 5)
Rotate t [VOL] to turn OFF the power to exit the
squelch level adjustment mode.
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]
To Next Page
Loading...
