Icom IC-F29SR - Setting the ringer level

4
SETTINGS
7
Setting the ringer level
Youcanadjusttheringerlevelbetween1and5,or1
(linked) and 5 (linked).
When a linked option is selected, you can adjust the
ringer level by rotating [VOL].
Rotate q [VOL] to turn OFF the power.
Set w [ROTARY SELECTOR] to Channel 16.
While holding down e [Lower], rotate [VOL] to turn
ON the power and enter the ringer level adjustment
mode.
Push r [Upper] to increase, or push [Lower] to de-
crease the ringer level as shown to the right.
 •A beep sounds after pushing [Upper]. Therefore, you
can determine the current level setting by the increasing
loudness of the beep that sounds.
 •Todetermineifyouhaveselectedalinkedlevel,set[VOL]
to minimum, then push [Upper] up to 10 times, listening
for the loudest beep (level 5). Pushing [Upper] once after
the loudest beep will select 1 (Linked). Repeatedly push
[Upper] or [Lower] to select the desired linked level.
Rotate t [VOL] to turn OFF the power to exit the ringer
level adjustment mode.
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Lower]
Pushing
[Upper]