Icom IC-F29SR - SETTINGS; Setting the Beep function

5
Section 4 SETTINGS
Setting the Beep function
The Beep function can be turned ON or OFF. When it is
OFF, the channel announcement is also turned OFF.
NOTE:YoushouldturnONtheBeepfunctionwhen
you set the microphone gain, the squelch level or the
group code number to check the current level setting
with the beep sounding. (pp. 8–11)
Rotate q [VOL] to turn OFF the transceiver power.
Set w [ROTARY SELECTOR] to any channel other
than Channel 16.
While holding down e [Lower], rotate [VOL] to turn ON
the power to enter the Beep level adjustment mode.
Push r [Lower] to turn the Beep function ON or OFF.
 •When a beep sounds after pushing [Lower], the Beep
function is ON. When no beep sounds after pushing
[Lower], the Beep function is OFF.
 •If desired, push [Upper] to adjust the Beep level. See
page 6 for details.
Rotate t [VOL] to turn OFF the power to exit the Beep
level adjustment mode.
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]