Icom IC-F29SR - Setting the beep level

4
SETTINGS
6
Youcan adjust the beep level between 1 and 5, or 1
(linked) and 5 (linked).
When a linked option is selected, you can adjust the
beep level by rotating [VOL].
Rotate q [VOL] to turn OFF the transceiver power.
Set w [ROTARY SELECTOR] to any channel other
than Channel 16.
While holding down e [Lower], rotate [VOL] to turn
ON the power and enter the beep level adjustment
mode.
Push r [Upper] to change the beep level as shown to
the right.
 •Abeepsoundseverytimeyoupush[Upper]. Therefore,
you can determine the current level setting by the in-
creasing loudness of the beep that sounds.
 •Todetermineifyouhaveselectedalinkedlevel,set[VOL]
to minimum, then push [Upper] repeatedly, listening for
the loudest beep (level 5). Pushing [Upper] once after
the loudest beep will select 1 (Linked). Repeatedly push
[Upper] to select the desired linked level.
Rotate t [VOL] to turn OFF the power to exit the beep
level adjustment mode.
Setting the beep level
[ROTARY SELECTOR]
[VOL]
[Lower]
[Upper]
2
5
4
3
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)
Pushing
[Upper]