Icom IC-F50V - Page 16

9
2
PANEL DESCRIPTION
MONITOR KEY
➥MuteandreleasetheCTCSS(DTCS)or2-tonesquelchmute.
Openanysquelch/deactivateanymutewhilepushingandhold-
ing this key. (LMRoperationonly)
➥Activatesoneof(ortwoof)thefollowingfunctionsoneach
channel independently: (PMRoperationonly)
 •Pushandholdtoun-mutethechannel(audioisemitted;‘Audible’
condition).
 •Pushtomutethechannel(setsto‘Inaudible’only).
 •Pushafterthecommunicationisfinishedtosenda‘resetcode’.
(BIISoperationonly)
NOTE:Theun-mutecondition(‘Audible’condition)mayauto-
maticallyreturntothemutecondition(‘Inaudible‘condition)
after a specified period.
LIGHT KEY
Push to turn the backlight ON for about 5 sec. even if the backlight
function is turned OFF in the User Set mode.
LONE WORKER KEY
PushtoturntheLoneWorkerfunctionONorOFF.
•IftheLoneWorkerfunctionisactivated,theEmergencyfunctionis
automatically turned ON after the specified time period has passed
with no operation is performed.
HIGH/LOW KEY
Push to select the transmit output power temporarily or perma-
nently,dependingonthepre-setting.
•Askyourdealerfortheoutputpowerlevelforeachselection.
C.TONE CHANNEL ENTER KEY
Push to enter the continuous tone channel selection mode, and
push[CHUp]/[CHDown]tochangethetonefrequency/codeset-
ting. The selected channel remains set as the continuous tone
channel until another channel is designated as such.