Icom IC-F50V - Page 17

10
2
PANEL DESCRIPTION
2
TALK AROUND KEY
Push to turn the talk around function ON and OFF.
•Thetalkaroundfunctionequalizesthetransmitfrequencytothere-
ceivefrequencyfortransceiver-to-transceivercommunication.
WIDE/NARROW KEY
Push to toggle the IF bandwidth between wide and narrow.
•Thewidepassbandwidthcanbeselectedfrom25.0or20.0kHz
usingtheCS-F50Vc l o n i n g s o f t w a r e .(PMRoperationonly)Ask
your dealer for details.
DTMF AUTODIAL KEY
➥ Push to enter the DTMF
channel selection mode. Then select
thedesiredDTMFchannelusing[CHUp]/[CHDown].
➥ After selecting the DTMF channel, push again to transmit the
selected DTMF code.
DTMF RE-DIAL KEY
Pushtotransmitthelast-transmittedDTMFcode.
•TXmemoriesareclearedafterturningthetransceiverOFF.
CALL KEYS
Pushtotransmita2/5-tone/BIISIDcode.
•Calltransmissionisnecessarybeforecallinganotherstationdepend-
ing on your signalling system.
•[CallA]and/or[CallB]maybeavailablewhenyoursystememploys
selective‘Individual/Group’calls.Askyourdealerwhichcallisas-
signed to each key.
SURVEILLANCE KEY
Push to turn the surveillance function ON or OFF.
WhenthisfunctionisturnedON,thebeepisnotemittedandthe
LCD backlight and the LED indicator do not light when a signal is
received or a key is pushed.