30
4
SELCALL/ALE OPERATION
2001 NEW 2001 NEW
Automatically establish a communication link by using
the ALE table.
• Sending an Individual call
q Hold down [ ] for 1 second to enter the Network
selection screen.
w Push [r] or [s] to select the desired Network, and
then push [ ].
• The Networks that belong to the ALE system must be
selected.
e Push [r] or [s] to select the Call Type to “Individ-
ual.”
• “Individual,” “NET Call,” “Individual AMD,” “NET AMD,”
“Sounding” “Individual Update LQA,” “NET Update LQA,”
“Unlink Individual AMD,” and “Unlink NET AMD” are select
-
able.
r Push [r] or [s] to select the Individual ID, and then
push [ ].
• Only the IDs that belong to the Network selected in step
w, are displayed.
t Push [r] or [s] to select the Self ID, then push
[ ].
• Only the IDs that belong to the Network selected in step
w, are displayed.
y Push [r] or [s] to select the Channel.
• Only the channels that belong to the Network selected in
step w, are displayed.
•
If <A
uto> is selected, the transceiv
er sequentially trans
- mits on channels that belong to the Network in the LQA
order.
u Push [ ] to transmit the Individual call.
• While calling, push [ ] or [PTT] to cancel the call.
• After calling, the transceiver waits for a response.
i When the response is received, the caller transceiv-
er automatically transmits the Acknowledgement.
• The call is saved in the Call Out memory.
• After an ALE call
➥ After an ALE call is finished, push [ ] to transmit
the disconnect call.
• If the “Auto Start Type” item of “Setmode” is set to “Scan”
or “Termination,” the Call automatically disconnects after
the Auto Start Wait Time period has past with no opera-
tion.
(Setmode > Call)
D ALE Individual/NET calls
To Next Page
Loading...
Need help?
General
