To Next Page
S
sandra39Sep 6, 2025
How to turn on beeps on Icom IC-GM1600E?
- RrmathisSep 6, 2025
If there are no beeps from your Icom Two-Way Radio, the beep tones are likely turned OFF. Set the beep tones to ON (Fix Beep/User Beep) in the SET mode.
How to turn on beeps on Icom IC-GM1600E?
If there are no beeps from your Icom Two-Way Radio, the beep tones are likely turned OFF. Set the beep tones to ON (Fix Beep/User Beep) in the SET mode.
Why is there no sound from my Icom IC-GM1600E Two-Way Radio speaker?
There could be several reasons why you're not hearing any sound: * The squelch level might be set too high. Try adjusting it to the threshold point. * The volume could be too low. Rotate the [VOL] knob to increase the volume to a suitable level. * The speaker may have water in it. Drain any water from the speaker. * The [MIC/SP] connector may be wet. Ensure the [MIC/SP] connector is dry.
Why can't I transmit or select high power on my Icom Two-Way Radio?
If you are unable to transmit or select high power, it could be due to: * A depleted battery. Replace the battery pack. * The output power is set to low. Push [Hi/Lo• ] to select high power.
Why is my Icom Two-Way Radio transmitting continuously with VOX, even when I'm not speaking?
If your radio transmits continuously while using the VOX function, even when you are not speaking, it may be caused by: * Loud ambient noise. Try removing the headset cable. * Incorrect VOX gain settings. Set the VOX gain to dulling.
General| Brand | Icom |
|---|---|
| Model | IC-GM1600E |
| Category | Two-Way Radio |
| Language | English |
Instructions for attaching the neckstrap to the transceiver for carrying.
Instructions for attaching the belt clip to the transceiver for mounting.
Overview of the transceiver's front, top, and side panel controls and buttons.
Explanation of icons and readouts on the transceiver's main LCD screen.
Description of specific indicators like battery, VOX, lock, and channel status.
Procedures for selecting distress Channel 16 and custom call channels.
Steps for powering on, setting volume, squelch, and performing basic communication.
Guide to programming custom call channels for quick recall and access.
How to properly adjust the squelch for clear signal reception without noise.
How to use the lock function to prevent accidental changes and the monitor function.
Information on signal strength indicators and using the voice-activated transmission (VOX) feature.
Steps to enter SET mode and an overview of available configurable functions.
Configuration options for beep tones, confirmation sounds, and monitor switch actions.
Adjusting LCD display contrast and performing device self-checks for diagnostics.
Settings for battery status display, voltage indication, and squelch sensitivity.
Adjusting VOX gain for sensitivity and VOX delay for transmission timing.
Key information and precautions for charging the battery pack safely.
Steps for charging the battery pack using specified chargers and adapters.
Diagrams and steps for connecting the BP-224 battery for charging.
Diagrams and steps for connecting the BP-252 battery for charging.
Details of the HM-125 speaker-microphone features, including clip and PTT switch.
Instructions on how to connect and detach the HM-125 speaker-microphone.
Details of available battery packs (BP-234, BP-224, BP-252) for different models.
Information on the MB-103Y belt clip accessory for carrying the transceiver.
Details on optional speaker-microphones (HM-125) and other accessories.
Steps for making an emergency distress call, including MAYDAY format.
Quick guide to programming custom call channels for efficient communication.
