Icom IC-M127

© Turning the auto fog horn ON and OFF
@® Push [HL/IC * A.FOG] for 1 sec.
* One or more “*er4" appear indicating the selected fog horn pat-
tern.
@ Push [HL/IC * A.FOG] for 1 sec. again to turn the function
OFF.
*“*er4" indications disappear.
© Selecting a fog horn pattern
@ Be sure the fog horn pattern is turned OFF.
* When turned ON (one or more “*er4" appear), push and hold
[HL/IC * A.FOG] to turn the function OFF.
® Push and hold [HL/IC * A.FOG] until step @ is finished.
@ After “»s4” (one or more) appears, rotate the channel se-
lector or microphone [UP)/[DN] switches until the desired
fog horn pattern is selected.
* The number of “*s4" appearing indicates the selected fog horn
pattern (see page opposite),
* At this time you can send a fog horn signal manually by pushing
[PTT].
OTHER FUNCTIONS 5
Bi Internal speaker ON/OFF
When you connect an external speaker and the transceiver's
internal speaker is not required, the internal speaker can be
deactivated. The internal speaker is turned ON and OFF in
SET mode. For details see p. 29.
Y NOTE: Even when the internal speaker is set to OFF, op-
Z tional DSC function alerts will sound when activated.
Bj Displaying position
When the optional OPC-457 (NMEA CABLE) and a GPS re-
ceiver is connected to the transceiver, your position can be
displayed at the push of a switch.
Push [16 * POS] for 1 sec. to display your cur-
rent vessel position.
am
25