Icom IC-M127 - Set Mode Configuration; Entering and Customizing Set Mode

mmm 6G 0 SET MODE
@ Entering SET mode
SET mode is used to customize operation of the transceiver
to suit your operating needs.
© To enter set mode:
@ While pushing [16], turn power ON.
+ SET mode is selected,
® To exit SET mode, turn power OFF then ON again.
© To select an item:
There are up to 10 items in SET mode (depending on options
installed) that may be adjusted to suit your operating prefer-
ences,
@ Select SET mode as above.
® Push [16] to select the desired item; then rotate the chan-
nel selector to select the desired condition.
* See the following pages for details on each SET mode item.
@ SET mode items
GY This diagram
Y shows the default uy
G
settings
for
each
ec
Cpe
Y SET mode item WEEP LEVEL)
Y and the order of Beep tone level (p. 27)
selection.
Y Items inside dotted ry fi
Y lines only appear SCAN TYPE
Z when optional units G=""* 11 E )
Z are installed. Scan type (p. 28)
on
SCAN TIMER
‘Scan timer (p. 28)