11
4
DUALWATCH/TRI-WATCH
3
4
■ Description
Dualwatch monitors Channel 16 while you are receiving
another channel; Tri-watch monitors Channel 16 and the call
channel while receiving another channel.
■ Operation
q Select Dualwatch or Tri-watch in Set mode. (p. 29)
w Select the desired operating channel.
e Push [CH/WX•
DUAL] for 1 sec. to start Dualwatch or Tri-
watch.
•“ ” blinks during Dualwatch; “” blinks during Tri-watch.
• A beep tone sounds when a signal is received on Channel 16.
r To cancel Dualwatch/Tri-watch, push [CH/WX•DUAL]
again.
DUALWATCH/TRI-WATCH SIMULATION
• If a signal is received on Channel 16, Dualwatch/Tri-watch
pauses on Channel 16 until the signal disappears.
• If a signal is received on the call channel during Tri-watch,
Tri-watch becomes Dualwatch until the signal disappears.
• To transmit on the selected channel during Dualwatch/Tri-
watch, push and hold [PTT].
To Next Page
Loading...
