28
SET MODE
New2001
7
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan type (Normal or Priority,) scan re-
sume timer, Weather alert, Dual/Tri-watch, DSC watch, trans-
ceiver’s beep tone and Auto ACK.
Available functions may differ depending on dealer setting.
D Set mode operation
q Turn power OFF.
w While pushing [16•
9], turn power ON to enter Set mode.
• “” appears on channel comment indicator.
e After the display appears, release [16•9].
r Push [16•
9] to select the desired item, if necessary.
t Push [Y] or [Z] to select the desired condition of the item.
y Turn power OFF, then ON again to exit Set mode.
D SET MODE CONSTRUCTION
To Next Page
Loading...
