Icom IC-M33 - Set Mode; Set Mode Programming; Set Mode Operation

17
7
SET MODE
6
7
■ Set mode programming
Set mode is used to change the settings for 11 transceiver
functions:Beeptonefunction,Priorityscanfunction
†
, Scan
resume timer
†
, Auto scan function
†
, Dual/Tri-watch function
†
,
Monitor key action, Automatic backlighting, LCD contrast set-
ting, Power save function, Squelch sensitivity and Low fix func-
tion*.
* Appears only when the optional battery case is attached; Not avail-
able with German version depending on the pre-setting.
†
Not available with Holland version.
D Set mode operation
q Turn power OFF.
w While pushing [SQL], turn power ON to enter set mode.
 •“bP”appears.
e Push [SQL] or [Y]/[Z] while pushing and holding [SQL]
to select the desired item, if necessary.
r Push [Y]/[Z] to select the desired setting of the item.
t To exit set mode, push [16].
D SET MODE ITEMS (The display shows the current settings, and the selected function is displayed in the dotted circle.)
• Auto scan
†
Starting item
• Beep tone• Low fix* • Scan resume timer
†
• Dual/Tri-watch
†
• Automatic
backlighting
• Power save • LCD contrast • Monitor key action
• Squelch sensitivity
• Priority scan
†
: Push
+ [Z]
: Push or
+ [Y]
*Appears only when the optional
battery case is attached; Not
available with German version
depending on the pre-setting.
†
Not available with Holland version.