Icom IC-M36

■ Set mode programming
Set mode is used to change the conditions of transceiver's
functions: beep tone function, weather alert function, priority
scan function, scan resume timer, auto scan function, dual/
tri-watch function, monitor key action, automatic backlight-
ing, LCD contrast setting, power save function, squelch sen-
sitivity, low fix function* and noise detection function.
*Appears only when the optional battery case is attached.
D Set mode operation
q Turn power OFF.
w
While pushing [VOL/SQL MONI], turn power ON to enter
set mode.
• “bP” appears.
e Push [VOL/SQL MONI], or push [Y]/[Z] while pushing
and holding [VOL/SQL MONI to select the desired item.
r Push [Y]/[Z] to select the desired condition of the item.
t To exit set mode, push [16 9].
D SET MODE ITEMS (The display shows the current settings, and the selected item is displayed in the dotted circle.)
• Auto scan
Starting item
• Beep tone• Noise detection
• Low fix*
• Scan resume timer
• Dual/Tri-watch
• Automatic
backlighting
• Power save • LCD contrast • Monitor key action
• Squelch sensitivity
• Priority scan• Weather alert
: Push
+ [Z]
: Push or
+ [Y]
*Appears only when the optional
battery case is attached.
17
7
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16