26
TROUBLESHOOTING
10
PROBLEM POSSIBLE CAUSE SOLUTION REF.
The transceiver does not turn
ON.
• The battery is exhausted.
• The battery pack is not attached cor
-
rectly.
• Recharge the battery pack.
• Attach the battery pack correctly.
p. 23
p. 3
No sound from speaker. • Squelch level is too high.
• Volume level is too low.
• Speaker has been exposed to water.
• Set squelch to the threshold point.
• Set the audio level to a suitable level.
• Drain water from the speaker.
p. 12
p. 11
p. 13
Transmitting is impossible,
or high power can not be se-
lected.
• Some channels are for low power or re
-
ceive only.
• The battery is exhausted.
• The battery over charged.
• The output power is set to low.
• Change channels.
• Recharge the battery pack.
• Make sure the battery voltage is correct.
• Push [Hi/Lo ] to select high power.
pgs. 8,
9, 27
p. 23
—
p. 10
The displayed channel cannot
be changed.
• Lock function is activated. • Push and hold [Hi/Lo ] for 1 sec. to
cancel the function.
p. 13
Scan does not start. • “TAG” channels are not programmed. •
Set the desired channels as “TAG” chan-
nels.
p. 15
No beeps. • Beep tone function is turned OFF. • Set the beep tone to ON (Fix Beep/User
Beep) in the set mode.
p. 18
Battery voltage error • The connected battery pack’s voltage is
more than 11 V.
• Make sure the battery voltage is correct.
—
To Next Page
Loading...
