Icom IC-M504

29
6
DSC OPERATION
6
r Rotate [DIAL] to select “Able to Comply” or “Un-
able to Comply,” push [DIAL•ENTER].
 •When“Unable to Comply” is selected, “No Reason
Given” will be transmitted.
t Push [DIAL•ENTER] to transmit the acknowledgement
call to the selected station.
y After the individual acknowledgement call has been
transmitted, the specified channel (specified by the call-
ing station) is selected automatically when “Able to
Comply” is selected, or returns to the previous condition
(before entering the DSC menu) when “Unable to
Comply” is selected in step r.
D Transmitting a group call
The group call function allows you to transmit a DSC signal
to a specific group only.
q Push [MENU] to enter the DSC menu.
w Rotate [DIAL] to select “Group Call,” p u s h
[DIAL•ENTER].
--DSC Menu--
Select Item
Position Input
Individual Call
˘Group Call
All Ships Call
Position Request
Position Report
e Rotate [DIAL] to select the desired pre-programmed group
address or “Manual Input,” push [DIAL•ENTER].
 •TheIDcodeforthegroupcallcanbesetinadvance.(p.19)
 •When“Manual Input” is selected, set the 8-digit ID code
for the group you wish to call by rotating [DIAL].
--DSC Menu--
Select Action
˘Able to Comply
Unable to Comply
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Individual ACK Ready
<CLR˘Exit / ENT˘OK>
--DSC Menu--
Select Address
Manual Input
˘Icom
Group A
<CLR˘Exit / ENT˘OK>