Icom IC-M602 - I Intercom Operation; I Channel Comments

76
13
HM-127 REMOTE-CONTROL MICROPHONE
■ Intercom operation
q Push [LO/DX•IC] for 1 sec. to ac-
tivate the intercom function.
• “IC” appears in the channel readout.
• The channel name disappears.
w Push [PTT] to talk.
•“ ” appears in the channel
name indicator.
e Release [PTT] to listen.
•“ ” appears in the channel name indicator when the trans-
ceiver is in talking mode.
r Push [LO/DX•IC] to cancel the intercom function.
• Pushing [16] also cancels the intercom function.
For your reference:
In case the intercom mode is selected with the transceiver
while the microphone power is OFF, the microphone power is
automatically turned ON and the intercom mode is selected.
DD
Intercom beep function
➥ Push [LO/DX•IC] for more than 1 sec.
• Emits the intercom beep while holding.
■ Channel comments
q Push [
YY
]/[
ZZ
] to select a channel to program the channel
comment.
• Push [CH/WX•U/I/C] several times while pushing [H/L] to select
the channel group (USA, INT, CAN), if desired.
w While pushing [H/L], push [16•9].
• The 1st character of the currently programmed comment flashes.
e Push [
YY
]/[
ZZ
] to select a character.
r Push [SQL] to move to right; then push [
YY
]/[
ZZ
] to select a
character.
• Push [VOL] to move to left.
t Continue until the desired characters have been selected,
then push [16•9] to return to normal operation.
• Available characters
(r)
(s) (t) (u) (v) (w) (x) (y) (z)
(q)
(3)
(D)
(N)
(X)
(h)
(+)
(4)
(E)
(O)
(Y)
(i)
(–)
(5)
(F)
(P)
(Z)
(j)
(✱)
(6)
(G)
(Q)
(a)
(k)
(/)
(7)
(H)
(R)
(b)
(l)
(,)
(8)
(I)
(S)
(c)
(m)
(space)
(9)
(T)
(d)
(n)
(0)
(A)
(U)
(e)
(o)
(1)
(B)
(V)
(f)
(p)
(2)
(C)
(J) (K) (L) (M)
(W)
(g)
(.)
( ))(( )(’)(&)( % )($)(#)(")(!)
Appears when the inter-
com function is in use.