Icom IC-M71 - Page 118

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0016 00
PREVENTIVE MAINTENANCE CHECKS AND SERVICES
0016 00-3
THIS SECTION COVERS:
Before Operation Preventive Maintenance Checks and Services (PMCS)
INITIAL SETUP:
Kitchen Set Up for Operation
Maintenance Level:
Operator/Crew
Table 1. Before Operation PMCS for CK
ITEM
NO.
INTERVAL MAN-
HOUR
ITEM TO BE
CHECKED OR
SERVICED
PROCEDURE EQUIPMENT
NOT READY/
AVAILABLE IF:
1 Before Container Inspect exterior of container for
obvious weld cracks, damage to door
hinges, handles, or seals. Check
doors for freedom of movement.
Lubricate door hinges as necessary
(WP 0051 00, Table 1, Item 6.).
Container
cracked or
damaged.
Inspect cam locks for loose, missing or
damaged hardware. Inspect weather
seals for deterioration or damage.
Cam locks
damaged.
Inspect bullseye and wing levels for
damage
Inspect jacks for damage, missing
parts, freedom of movement.
Lubricate corner jacks as necessary
(WP 0051 00, Table 1, Item 4).
Jack cracked or
bent, locking pins
missing.
Inspect stair/ladders and railings for
damage, cracked welds.
Any cracked
welds.
Inspect winches for missing or
damaged hardware, freedom of
movement.
Missing or
damaged
hardware.
Inspect winch cables for proper
tension, routing and fraying.
Any frayed strand
or more than one
flat spot on cable.
Inspect inner and outer fabric, floor
covering and window screens for
holes, tears, or loose seams. Inspect
hook and loop closures for damage
and proper operation.
Inspect tie-down provisions for
damage, loose or missing hardware
Damaged, loose,
hardware
missing.