Icom IC-M71 - Page 166

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0026 00
UNIT MAINTENANCE PROCEDURES
0026 00-5
Main Control Panel:
Switch/Lamp Replacement: Make sure the external power source is disconnected and the
generator is shut down. Referring to Figure 4, label and remove the spade lugs from the
switch/lamp to be replaced. Remove the mounting hardware from the front of the panel and
remove the switch/lamp assembly. Install the replacement switch/lamp assembly, replace
hardware and reconnect spade lug terminals.
INTERIOR
INTERIORINTERIOR
INTERIOR
LIGHTING
LIGHTINGLIGHTING
LIGHTING
NORMAL
NORMALNORMAL
NORMAL
BLACKOUT
BLACKOUTBLACKOUT
BLACKOUT
LIGHTING
LIGHTINGLIGHTING
LIGHTING
MODE
MODEMODE
MODE
LIGHT
LIGHTLIGHT
LIGHT
EMERGENCY
EMERGENCYEMERGENCY
EMERGENCY
OFF
OFFOFF
OFF
ON
ONON
ON
POWER ON
POWER ONPOWER ON
POWER ON
GENERATOR
GENERATORGENERATOR
GENERATOROFF
OFFOFF
OFF
POWER ON
POWER ONPOWER ON
POWER ON
EXTERNAL
EXTERNALEXTERNAL
EXTERNAL
SYSTEM POWER SELECTION
SYSTEM POWER SELECTIONSYSTEM POWER SELECTION
SYSTEM POWER SELECTION
POWER
POWERPOWER
POWER
AVAILABLE
AVAILABLEAVAILABLE
AVAILABLE
GENERATOR
GENERATORGENERATOR
GENERATOREXTERNAL
EXTERNALEXTERNAL
EXTERNAL
POWER
POWERPOWER
POWER
AVAILABLE
AVAILABLEAVAILABLE
AVAILABLE
OFF
OFFOFF
OFF
ON
ONON
ON
Figure 4. Main Control Panel.