Icom IC-M94DE - Waypoint Editing and Navigation; Editing and Deleting Waypoints; Navigating to a Selected Waypoint

47
10
AIS RECEIVER
■ Using the AIS list screen
There are 3 types of AIS lists, Target, Danger, and Friends.
1. Push [MENU].
• The Menu screen is displayed.
2. Push [▲] or [▼] to select “AIS,” and then push [ENT].
• The “AIS” screen is displayed.
3. Push [▲] or [▼] to select a list, and then push [ENT].
• The list screen is displayed.
4. Push [▲] or [▼] to select an AIS target.
5. Push the Software Key below for your next operation.
:
(DSC)
Displays the “Compose Other” screen to send
an Individual call. (p. 28)
L Displayed only when a target is selected.
L May not be displayed, depending on the
selected target.
:
(Navigation)
Starts navigation to the selected target.
(p. 59)
:
(Friend)
Sets the selected target as a Friend. (p. 49)
L Displayed only in the Target List or Danger
List.
:
(Detail)
Displays the details on the selected target.
(p. 50)
L Displayed only when the target is selected.
:
(Plotter)
Displays the selected target on the plotter
screen. (p. 45)
:
(Sort)
Sorts the Danger target data by CPA or TCPA.
L Displayed only in the Danger List.
NOTE: An alarm sounds when an AIS target is closer than
the CPA and TCPA settings, and so on, depending on the
presetting. To stop the alarm buzzer, push any key.
L If the popup screen is displayed, push any key again to turn it
OFF.