Icom ID-880H

3
2
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
± During FM/FM-N mode operation, push and hold for 1
sec. to enter tone function selection state.
(pgs. 86, 91)
• Rotating [DIAL] selects the tone function.
• T (Repeater tone), TSQL
, TSQL, DTCS , DTCS, tone
squelch reverse, DTCS squelch reverse or tone function OFF
can be selected.
± During DV mode operation, push and hold for 1 sec. to
select digital call sign squelch, digital code squelch and
no squelch operation in sequence. (p. 149)
• DSQL , DSQL, CSQL , CSQL or digital call squelch
OFF can be selected.
u D-STAR REPEATER•YOUR KEY [DR•UR]
± Push to select DR mode.
(p. 21)
• Rotating [DIAL] selects access repeater.
• DV mode is automatically selected.
± During DV mode operation, push and hold for 1 sec. to
enter your call sign selection state.
(p. 30)
• Rotating [DIAL] selects your call sign.
• DV mode is automatically selected.
i CALL SIGN•RX CALL WRITE KEY [CS•RXCS]
± Push to display the current call sign.
(p. 21)
• Rotating [DIAL] selects UR (your) call sign, R1 (access re-
peater) call sign, R2 (link repeater) call sign and MY (your
own) call sign.
± Push and hold for 1 sec. to set the received call signs
(stations and repeaters) to current call sign.
(p. 30)
o OUTPUT POWER•DUPLEX KEY [LOW•DUP]
± Each push changes the output power selection.
(p. 21)
• LOW, MID and HIGH (no indicator visible) are available.
± Push and hold for 1 sec. to enter duplex operation se-
lection state.
(p. 30)
• Rotating [DIAL] selects the tone function.
• DUP– (minus duplex), DUP (plus duplex) and simplex (no
indicator visible) are available.
!0 MONITOR•DTMF KEY [MONI•DTMF]
± Push to turn the monitor function ON and OFF.
(p. 24)
± Push and hold for 1 sec. to enter DTMF set mode.
(p. 82)
!1 SQUELCH CONTROL [SQL]
Varies the squelch level for left and right band.
(p. 20)
• The RF attenuator activates and increases the attenuation when
rotated clockwise at and beyond the center position. (p. 22)
!2 POWER KEY [PWR]
Push and hold for 1 sec. to turn power ON and OFF.
!3 MICROPHONE CONNECTOR
(p. IV)
Connects the supplied or an optional microphone.
:
2
q +8 V DC output (Max. 10 mA)
w Channel up/down
e 8 V control IN
r PTT
t GND (microphone ground)
y MIC (microphone input)
u GND
i Data IN
!4 VOLUME CONTROL [VOL] (p. 20)
Adjusts the audio level for left or right band.