Icom ID-880H

2
2
BASIC OPERATION
q MENU•LOCK KEY [MENU ]
± Push to enter menu screen indication ON and OFF.
(p. 7)
± Push and hold for 1 sec. to toggle the lock function ON
and OFF.
(p. 19)
w SELECT MEMORY WRITE•MEMORY WRITE KEY
[S.MW•MW]
± Push to enter select memory write mode for memory
channel programming.
(pgs. 62, 73, 76)
• Push [MENU ] to cancel and exit the select memory write
mode.
± Push and hold to store the frequency, operating mode,
etc. into the selected memory channel.
(pgs. 62, 73, 76)
e TUNING DIAL [DIAL]
Selects the operating frequency
(p. 17), memory channel
(p. 61), the setting of the set mode item and the scanning
direction
(p. 75).
r BAND•MODE KEY [BAND•MODE]
± Push to enter band selection state.
(p. 15)
• Rotating [DIAL] selects the band.
± Push and hold for 1 sec. to enter operating mode selec-
tion state.
(p. 15)
• Rotating [DIAL] selects the operating mode.
t VFO/MHz TUNING•SCAN KEY [VFO/MHz•SCAN]
± Push to select VFO mode.
(p. 17)
± During VFO mode operation, push to select 1 MHz and
10 MHz tuning steps.
(p. 75)
± Push and hold for 1 sec. to enter scan type selection
state.
(p. 75)
• Cancels a scan when pushed during scan.
y MEMORY/CALL•TONE KEY [M/CALL•TONE]
± Push to select memory, call and weather channel*
modes.
(pgs. 61, 72, 123)
*Weather channels are available for USA version only.
N Front panel— controller
VFO/MHz
BAND
MODE
VOL
SQL
M/CALL CSDR LOW MONI
S
.
M
W
M
W
M
E
N
U
uytr!0oi
Function display (p. 3)
w
q
e
!4
!3!2!1