Icom ID-880H

4
1
PANEL DESCRIPTION
N Function display
!1!8 !6 !4 !2!5 !3
o
!0
q
w
!7
i
rty u
e
Function guide (p. 5)
q TRANSMIT INDICATOR
± Appears while transmitting.
(p. 17)
w CALL SIGN TYPE INDICATORS
“MY” appears when your own call sign; “UR” appears when
station call sign; “R1” appears when access repeater call
sign and “R2” appears when link repeater call sign is se-
lected.
e FREQUENCY READOUT
Shows the operating frequency, set mode contents, etc.
• Frequency decimal point blinks while scanning. (p. 75)
r OUTPUT POWER INDICATORS
“LOW” appears when low output power; “MID” appears
when middle output power, no indication appears when
high output power is selected.
t OPERATING MODE INDICATOR
(p. 21)
Shows the selected operating mode.
• FM, FMN (FM narrow), AM, NAM (AM narrow) and DV (Digital
voice) are available.
• “DVG” “DV A” appears when GPS transmission or GPS-A trans-
mission is selected in DV mode. (p. ???)
y BUSY INDICATOR
± Appears when a signal is being received or the squelch
is open.
(p. 20)
± Blinks while the monitor function is activated. (p. 24)
u S/RF INDICATORS
± Shows the relative signal strength while receiving sig-
nals.
(p. 20)
± Shows the output power level while transmitting. (p. 21)