Icom ID-880H

12
2
BASIC OPERATION
D VFO mode
VFO mode is used to set the desired frequency.
± Push [VFO/MHz] to select VFO mode.
• When VFO mode is already selected, the digits to the right of the
10 MHz or 1 MHz digits will disappear depending on version. In
this case, push [VFO/MHz] again (or twice depending on ver-
sion).
[VFO/MHz]
• VFO mode indication
VFO/LOCK
± Push [VFO/LOCK] to select VFO mode.
What is VFO?
VFO is an abbreviation of Variable Frequency Oscillator. Fre-
quencies for both transmitting and receiving are generated
and controlled by the VFO.
D Memory mode
Memory mode is used for operation on memory channels
which store programmed frequencies.
q Push [M/CALL] to select memory mode.
• Push [M/CALL] several times to select Memory/Call/Weather*
channels in sequence. * Weather channels are available for the
U.S.A. version only.
• “X” indicator appears when memory mode is selected.
Appears
[M/CALL]
• Memory mode indication
w Rotate [DIAL] to select the desired memory channel.
• Only programmed memory channels can be selected.
• See p. 92 for memory programming details.
MR/CALL
Y/Z
z Push [MR/CALL] to select memory mode.
x Push [] or [] to select the desired mem-
ory channel.