18
2
BASIC OPERATION
N Selecting output power
The transceiver has 3 output power levels to suit your operat-
ing requirements. Low output powers during short-distance
communications may reduce the possibility of interference to
other stations and will reduce current consumption.
± Push [LOW] several times to select the output power.
*approx.
• The output power can be changed while transmitting.
The microphone can also be used to select output power.
± Push [HIGH 4(DTCS)] for high output power;
[
MID 5(DTCSS)] for middle output power; and
[
LOW 6(DTMF)] for low output power.
• The output power can be changed via the microphone
during receive only.
N Operating mode selection
Operating modes are determined by the modulation of the
radio signals. The transceiver has total 5 operating modes
(FM, FM-N, AM, AM-N and DV* modes). The mode selection is
stored independently for each band and memory channel.
Typically, AM mode is used for the air band
(118–136.995 MHz),
and receive is only available.
q Select the desired frequency band in VFO mode, or the
desired memory channel.
w Push and hold [MODE](BAND) for 1 sec., then rotate
[DIAL] to select the desired operating mode from FM,
FMN, AM, NAM and DV.
To Next Page
Loading...
