Icom ID-880H

6
1
PANEL DESCRIPTION
D Function guide indicator
The function guide indicators allow you to simply using a vari-
ety of functions. Two types of guide are available.
• Secondary function guides
VFO/MHz M/CALL CSDR LOW MONI
These function guides indicate the secondary functions for
below the keys. Push and hold for 1 sec to activate the indi-
cated functions. See page 1 to 2 (t to !0).
• Set condition guides
VFO/MHz M/CALL CSDR LOW MONI
qwer
Set condition guides appear when the transceiver enters
menu screen, select memory write state, optional UT-123 is
installed and GPS function is set to ON.
q CLEAR KEY [CLR](DR)
(p. 39)
± During programming state for call signs, repeater list,
memory name, etc., push to erase the selected char-
acter.
± During programming state for call signs, repeater list,
memory name, etc., push and hold for 1 sec. to erase
all character following the corsor.
w LEFT KEY [](CS)
± During programming state for call signs, repeater list,
memory name, etc., push to move the cursor left.
± During menu screen operation, push to select the upper
layer. (p. 113)
e RIGHT KEY [](LOW)
± During programming state for call signs, repeater list,
memory name, etc., push to move the cursor right.
± During menu screen operation, push to select the lower
layer. (p. 113)
r ENTER KEY [
](MONI) (p. 48)
± During menu screen operation, push to enter or exit
to/from the selected set items, etc. (p. 113)
± During programming state for call signs, repeater list,
etc., push to set or store the setting.