4-2
■ INSTALLING THE UNIT
1) Remove the screws, and then remove the top cover.
2)
Carefully remove three cables (123), as shown below.
1
2
3
3) Remove the five screws.
Screws
4) Remove the PCB (FRONT-R UNIT: 1), and then attach
the unit (2).
1
2
5)
Secure the unit using the screws removed in step 3.
L Firmly tighten the screws in the order shown below.
23514
6) Reattach the cables removed in step 2.
Cables
7) Remove the two caps on the rear panel, as shown
below.
Cap
(Continued on the next page)
To Next Page
Loading...
