Why Icom ID-RP2010V does not turn ON?
The Icom Repeater might not be turning on due to several reasons: a poor connection with the connector or DC power cable (check the connector pins and reconnect the DC power cable), the external power unit being turned off (confirm the external power unit is turned on), or a blown fuse (fix the problem and then replace the fuse).
Why Icom ID-RP2010V sensitivity is low and only strong signals are heard?
Low sensitivity on your Icom Repeater, where only strong signals are audible, can be due to issues with the antenna or coaxial cable. Inspect the coaxial cable and antenna connector, and replace them if necessary.
What to do if Icom Repeater does not repeat the received signal?
If your Icom Repeater isn't repeating the received signal, there might be incorrect settings. Verify the mode setting (FM or DV), the operation frequency setting, the tone setting, the callsign setting, and the IP address setting.
What to do if both [TX] and [RX] indicators blink at same time on my Icom ID-RP2010V Repeater?
If both the [TX] and [RX] indicators are blinking simultaneously on your Icom Repeater, it indicates that the repeater settings have been reset to default. You should set the operation frequency and tone.
What to do if Icom Repeater does not transmit output power, or transmits low output power?
If your Icom Repeater is not transmitting output power, or the output power is low, the issue might be with the antenna or coaxial cable. Check these components and replace the coaxial cable or the antenna connector if needed.
How to turn OFF Icom ID-RP2010V?
To turn off the Icom Repeater, hold down the [POWER] button until its green indicator turns off.
What to do if there was a problem with the operation of Icom ID-RP2010V?
If you experience an operational problem with the Icom Repeater, possibly due to external factors like static electricity, turn OFF the repeater, remove and reattach the external power unit, and then turn the repeater back ON.
Why I cannot connect to other Icom ID-RP2010V sites?
If you're unable to connect to other repeater sites using your Icom Repeater, the cause might be that you cannot connect to the Gateway server from the WAN port. Confirm that accessing from a WAN port is enabled on your router.
To Next Page
General
