Icom ID-RP2010V - Software and Mode Settings; Utility Software Connection; DV;DD Switch Operation

USING AN SD CARD
10
2
Using an SD card
1. Insert an SD card (1).
2. While holding down the Reset switch (2)*, turn
ON the repeater(3).
*Hold down using the tip of the pen or pin.
3. Remove the pen or pin from the Reset switch.
• The repeater enters to the Maintenance mode.
• Indicators blink (4).
1
2
3
4
Reset switch
4. Operate as shown below.
Updating the rmware:
z Push [POWER].
• [RX] ( ) and [TX] ( ) rapidly blink.
Reading the setting data:
1) Push the Reset switch.
• [RX] ( ) blinks once, and then [TX] ( ) blinks
twice.
• The indicator on [POWER] (
) blinks.
2) Push [POWER].
• [RX] ( ) and [TX] ( ) rapidly blink.
Reading the voice data for ID announce:
1) Push the Reset switch twice.
• [RX] ( ) blinks once, and then [TX] ( ) blinks
3 times.
• The indicator on [POWER] (
) blinks.
2) Push [POWER].
• [RX] ( ) and [TX] ( ) rapidly blink.
Saving the settings to an SD card:
1) Push the Reset switch 3 times.
• [RX] ( ) blinks once, and then [TX] ( )
blinks 4 times.
• The indicator on [POWER] (
) blinks.
L Push the Reset switch again to return to Step 1.
2) Push [POWER].
• [RX] ( ) and [TX] ( ) rapidly blink.
5. [RX] ( ) blinks twice, and then the [POWER]
( ) blinks once, if the operation successfully
finished.
L [TX] ( ) blinks if the operation fails.
L If the operation fails, check the saved le name and
data contents, and then retry from Step 2.
D Using the Maintenance mode
Use the Maintenance mode as shown below.
Operation
Status (
●: TX ●: RX)
Push
[POWER]
(
) while
holding
down the
Reset switch
Enter the Maintenance Mode.
(Firmware Update mode is selected)
(····
················ ····)
↳ Push the
Reset switch
Selecting the Setting Data Reading mode.
( ············ ····)
↳ Push the
Reset switch
Selecting the Voice Data Reading mode.
(
········ ····)
↳ Push the
Reset switch
Selecting the Setting Data Saving mode.
(
···· ····)
↳ Push the
Reset switch
Returns to the Firmware Update mode.
( ··················· ····)
↳ Push
[POWER]
(
)
Starts operating in the mode selected in
Step 2.
( ········ ········ )