USING THE UTILITY FOR ID-RP3
8
1
D Programming using an SD card
NOTE: Format the SD card on your PC before using.
1. Saving repeater setting to an SD card
z Enter the Maintenance mode, and then save the
repeater setting data to an SD card. See page 10
for details.
2. Copying repeater settings to your PC
1. Remove the SD card, and then insert it into your
PC.
2. Open the “Setting” folder on the SD card.
3. Copy the setting file (icf) to your PC.
3. Opening the utility
1. Double-click “ID-RP3” shortcut on the desktop.
• The Initial Setup Window is displayed.
2. Click <Cancel> to display the programming
screen.
4. Editing the data
1. Click “
” or select <Open...> in the <File> menu
to open the data.
2. Edit the setting data. See the Utility for ID-RP3
HELP that comes with the utility for details.
5. Writing the data to the repeater
1. Click “
” or select “Save As...” in the <File> menu
to save the data.
2. Copy the saved setting file (icf) to the “Setting”
folder on the SD card.
3. Remove the SD card, and then insert it into the
repeater.
4. Enter the Maintenance mode, and then write
the setting data to the repeater. See page 10 for
details.
Programming the repeater
NOTE: If multiple repeaters are connected, only the
repeater settings with the SD card inserted will be
saved. To save all repeater’s settings into a single
setting le (icf), read them to the utility using a USB
cable, and then save them to an SD card.
To Next Page
Loading...
