18
5
RESETTING
Resetting the repeater
Reset the repeater if somehow the repeater does not
properly operate.
1. Turn OFF the repeater.
2. Remove the DC power cable.
3. Wait for few seconds, and then attach the DC
power cable.
4. Turn ON the repeater.
If the trouble is not solved, reset the repeater as
shown below.
NOTE: If possible, backup the repeater settings
before resetting.
1
2
3
Reset switch
4
1. While holding down the Reset switch (1)*, turn
ON the repeater (2).
L Keep holding down the Reset switch for 10 seconds,
until the indicators blink (3).
*Hold down using the tip of the pen or pin.
2. Remove the pen or pin from the Reset switch.
3. Push the Reset switch again.
• The Indicators slowly blink (4).
To Next Page
Loading...
