FM REPEATER SETTING
16
4
Utility for ID-RP3 settings (ID Output)
D ID Output settings
Set conditions for outputting an ID.
L Write a voice data to the repeater if you select “Voice” in
“ID Select” (p. 9).
D ID Output settings (Common)
Set mixing volume levels for in case of outputting an
ID while the repeater operates.
D ID Output settings (CW)
Set key speed, CW pitch, and code for outputting an
ID by CW.
Utility for ID-RP3 settings (Signaling)
D Signaling (TX) settings
Tone settings for downlink signal.
D Signaling (RX) settings
Tone settings for uplink signal.
To Next Page
Loading...
