5-2
[REF IN 10MHz]
[REF IN 10MHz] Description
SMA connecter
Inputs a 10 MHz signal as a reference frequency signal.
• Input frequency: 10 MHz
•
•
[USB]
[USB] Description
Connects to the PC with a supplied USB cable to set the details of the repeater,
such as the callsign, frequencies, IP address, and any other functions using the
utility software.
•
[EXT-SP (SERVICE)]
[EXT-SP (SERVICE)] Line Name Description
GND
MIC
AF/DTMF
Received audio or DTMF tone signal output port.
•
•
MIC
Audio input port for adjustment.
Connects to an audio generator.
Refer to ADJUSTMENT PROCEDURE for details.
• REAR PANEL
[CONT I/O]
[RPT1]/[RPT2]
[USB]
[EXT-SP (SERVICE)]
[REF IN 10MHz]
[CONT I/O]
[CONT I/O] Description
Connects to the LAN port of the ID-RP2C using a supplied control cable,
when the repeater system is operating as a gateway or assist repeater with the
ID-RP2C.
L
[RPT1]/[RPT2]
[RPT1]/[RPT2] Description
Connects to other repeaters using the supplied control cable for data
communications, when multiple repeaters are installed in the repeater system.
L
To Next Page
Loading...
