■ INSTALLING THE ADJUSTMENT SOFTWARE (ID-RP3 ADJ)
When installing the software, confirm Windows has completed its startup, and then log in as the administrator.
■ BEFORE CONNECTING THE REPEATER TO THE PC
To use the USB cable between the repeater and a PC, you must first install a USB driver.
The latest USB driver and installation guide can be downloaded from the Icom website.
Carefully read the guide, before installing the driver.
https://www.icomjapan.com/support/firmware_driver/
■ IF A COMMUNICATION ERROR MESSAGE APPEARS
Check the following if an error message appears.
• The correct port number is set in the [COM Port] menu.
• The repeater and PC are correctly connected together with the cloning cable.
• The repeater is turned ON.
1) Confirm no other applications are running.
Double-click “setup.exe.”
• If “User Account Control” is displayed, click <Yes> to
continue.
3) Select “English” (or “Japanese”) and then click <Next >>.
• In this document, “English” is selected.
4) “Welcome to the InstallShield Wizard for ID-RP3 ADJ” is
displayed.
Click <Next >>.
5) “Choose Destination Location” is displayed. Click <Next >>.
• If desired, click <Browse...> to select another destination
folder before clicking <Next >>.
6) After the installation has completed, “InstallShield Wizard
Complete” is displayed.
Click <Finish>.
An ‘ID-RP3 ADJ’ group is created on the menu, and a
shortcut icon is created on the desktop.
To Next Page
Loading...
