Icom ID-RP2010V - Page 30

6-5
■ ABOUT THE ADJUSTMENT SCREEN
On the Adjustment screen, you can adjust the repeater.
• Perform the Repeater All Reset after you have finished the adjustment.
Idling current adjustment
(Automatic)
Transmit output power adjustment
(Manual)
Transmit balance adjustment
(Manual)
Receive adjustments
(Automatic)
■ COMMON ADJUSTMENT PROCEDURE
For the Automatic adjustments
1) Click on the adjustment value in hexadecimal for the item.
• The cell is highlighted in blue and selected.
 Push the PC's [ENTER] key.
• “OK” is displayed and the adjustment value is stored.
For the Manual adjustments
1) Click on the adjustment value in hexadecimal for the item.
• The cell is highlighted in blue.
 Push the PC's [ENTER] key.
• The cell is selected.
3) 
4) If you want to cancel the adjustment, push the PC's [ESC] key.
• The adjustment value returns to its original value.
5) Push the PC's [ENTER] key.
• “OK” is displayed and the adjustment value is stored.
ALC and DRIVE GAIN adjustments
(Automatic)
Reference frequency adjustment
(Automatic)
• Click [Start] to start the adjustment.
• Click [Stop] to quit the adjustment.
“VHF” is displayed when the repeater setting
data have been successfully loaded.
“OK” is displayed when the automatic adjustment is successfully finished.
“OK” is displayed when the automatic adjustment is successfully finished.
Adjustment value in hexadecimal
Adjustment value in hexadecimal
Adjustment value in hexadecimal
“OK” is displayed.
Adjustment item
Adjustment item