23
6
ATA/AIS
You can change the target settings for AIS operation
same as ATA operation. See pages 7 or 19 for TAR-
GET menu details.
DTARGET menu
■AIS operation
Select a target whose information you want to display
on the screen.
q Push [EBL1 (VRM1)]/[
] and [EBL2
(VRM2)]/[ ] to select the AIS operating
mode.
w Push [p], [q], [t] or [u] to move the “+” cursor
onto a desired target.
e Push [TARGET]/[ ] to select the target.
• A square of only four corners appears on the cursor.
• The target information appear in the AIS data area.
- AIS Class, MMSI number, bearing, distance, Course
Over Ground (COG), Speed Over Ground (SOG),
CPA and TCPA appear.
- The position information and Vessel name are alter-
nately displayed.
• If several targets are overlapped on the screen, push
[TARGET]/[
] to sequentially select a target.
• Hold down [TARGET]/[
] for 1 second to toggle the
selected target between activated and sleeping.
• Push [EBL1 (VRM1)]/[
] and [EBL2
(VRM2)]/[
] to toggle between the AIS op-
erating mode and the normal operating mode.
AIS Classes/target type
Bearing
Course Over Ground
Distance
Speed Over
Ground
Target Position/Vessel name
MMSI number
Closest Point of Approach
Time to Closest Point
of Approach
■ AIS settings (Continued)
To Next Page
Loading...
