8
INSTALLATION AND CONNECTIONS
29
• SX-3230
MOB
GAIN
SEA
RAIN
POWER
TX
SAVE
TARGET
TRAILS
ZOOM
TLL
ALM
MODE
OFF CENT
EBL1
VRM1
AIS
BRILL MENU
HL OFF
EBL2
VRM2
AUTO
300 (11.81) 119.2 (4.69)
30 (1.18)
74 (2.91)
293 (11.54)
323 (12.72)
146.5 (5.77)146.5 (5.77)
• SX-3230 Mounting Bracket
256 (10.08)
199 (7.83)
99.8 (3.93)
92 (3.62)
62 (2.44)
31 (1.22)
Ø7 (0.28)×4
Ø7 (0.28)
Fig. 1
• Mounting Bracket installation
Fig. 2
Flat washer
Spring washer
Bolt
Spring washer
Flat washer
Knob bolt
Nut
■ Installing the display unit
DLocation
Select a place for installation which meets the follow-
ing important conditions:
➥ The display unit should be placed near the wheel
in the cabin so that an operator may easily view the
radar screen while facing the bow.
➥ To minimize interference, KEEP the unit AT LEAST
THE COMPASS SAFE DISTANCE stated in the se-
rial number label on the rear panel away from the
compass and navigation receiver.
➥ Select a position where there is no danger of salt or
fresh water spray or immersion.
➥ Select a location where it is easy to perform mainte-
nance or adjustment after installation.
➥ Select a location which can support the weight of
the display unit.
➥ DO NOT select areas subject to extreme heat, cold,
vibrations or direct sunlight.
DMounting
The mounting bracket supplied with the display unit al-
lows “dashboard” or “overhead” mounting.
q Hold the mounting bracket up to the selected lo-
cation and mark pilot holes for the five installation
holes using the template.
• The template is provide on page 44.
w Drill five holes, 7 mm (0.28 in) in diameter as shown
in the diagram. (Fig. 1)
e Install the bracket using the knob bolts, bolts, nuts
or washers with the supplied accessories. (Fig. 2)
r Adjust the display unit to an adequate view angle.
• Front cover attachment
To Next Page
Loading...
