11
39
ERROR MESSAGE
■ Error message list
*
1
Push any key to cancel the error message and beep tone. Turn OFF the power, then check the external data
cable connection.
*
2
An electricity failure may occur, turn OFF the power, then consult your dealer or service person.
*
3
Push any key to cancel the error message and beep tone.
*
4
Turn OFF the power, then check the system cable connections.
■ AIS error message list
An error message is displayed when a system error is received from the AIS unit.
See the AIS unit instructions for details.
(Some examples)
Message contents
AIS: TX MALFUNCTION
AIS: ANTENNA VSWR EXCEEDS LIMIT
AIS: RX CHANNEL 1 MALFUNCTION
AIS: RX CHANNEL 2 MALFUNCTION
AIS: RX CHANNEL 70 MALFUNCTION
AIS: GENERAL FAILURE
AIS: MKD CONNECTION LOST
AIS: EXTERNAL EPFS LOST
AIS: NO SENSOR POSITION IN USE
AIS: NO VALID SOG INFORMATION
AIS: NO VALID COG INFORMATION
AIS: HEADING LOST/INVALID
AIS: NO VALID ROT INFORMATION
Only the first 29 digits of the error message are displayed. If the message is longer than 30 digits, “...” is displayed
after the 29th digit.
Message Condition
BRG INPUT FAIL*
1
• The Azimuth signal is interrupted. An alarm sounds within 5 seconds and
the display reverts to H UP mode in approximately 1 minute.
TRIG SIGNAL FAIL*
1
• If the TRIGGER signal is interrupted for more than 15 seconds, an
alarm sounds.
SHM SIGNAL FAIL*
2
• If the SHM signal is interrupted for more than 15 seconds, an alarm
sounds.
POSN INPUT FAIL*
1
• If the position signal is interrupted for more than 15 seconds, an
alarm sounds.
CHECK SCANNER CONNECTION*
4
• The system cable may not be properly connected.
To Next Page
Loading...
