TUNNEL MASTER JR MANUAL
Wash Configuration 35
Accessing a Password Protected Menu
Introduction
Once a password has been set into the system any access desired to the
menu options will require that the user enter the password that has been set
into the system.
Important!
For ease of setup in this manual it will be assumed that the user will have
entered the correct password to enter the main menu to setup and access
the system.
Procedures
Follow these procedures to enter the system password.
Step Action Screen Displays
1 Press the Menu key from the
main screen display
ICS OEM Tunnel Controller 10:25:35 PM
VER 1 REV 5.11 04/15/2002
Password _ _ _ _ _ _
ADDR =1 CARS 0000
2 Using the numeric keypad,
type in the first letter of the
password.
Example: For the letter “L”
press the “4” key three times
ICS OEM Tunnel Controller 10:25:35 PM
VER 1 REV 5.11 04/15/2002
Password * _ _ _ _ _
ADDR=1 CARS 0000
3 Wait until the cursor moves
to the next position
Warning: If you press ENT
after entering a letter, what
you have entered to that
point will be accepted as
your the password and you
will be returned to the main
screen display!
ICS OEM Tunnel Controller 10:25:35 PM
VER 1 REV 5.11 04/15/2002
Password * _ _ _ _ _
ADDR=1 CARS 0000
4 Repeat steps 3 & 4 until the
entire password is entered.
ICS OEM Tunnel Controller 10:25:35 PM
VER 1 REV 5.11 04/15/2002
Password ****_ _
ADDR=1 CARS 0000
5
Press the “ENT” button to
accept the password.
[1] Shift Break [4] View Counts
[2] Wet Down Wash [5] Print Reports
[3] Configure Wash
To Next Page
Loading...
Need help?
General